flag_long_base_V1.stl:

	Elongated base suited for locomotives with longer front-decks.
	
	Suited for:
	-C57
	-C55*
	-C11
	-C50
	-8620*
	(* not tested; Should fit fine, no guarantee though) 

flag_wide_base_V1.stl:

	Wider base suited for locomotives with shorter front-decks. If in doubt use this version as the foot print is smaller and more versatile.
	
	Suited for:
	-D51
	-C12
	-C56
	-C59*
	-C62**
	(* not tested; Should fit fine, no guarantee though)
	(** not the best fit, a new version **might** follow at some point, though this one is definetly "good enough" for now)



Both models were printed with a Anycubic Photon Mono 4 using Suraya Tech Fast Grey with Siraya Tech's recommended settings.
Supports were auto-generated using light supports with the models being angled at 45 degrees. No rafts were needed

Due to the size and fragility of the models, the supports were removed after final curing using tweezers and a hobby knife.


To avoid damage to your models, I highly recommend only using temporary methods of attaching the flags such as Tacky Wax and double-sided tape.



Last updated on: 17.12.2025

(Print and use at your own risk)

The files shared on this folder are shared under a NonCommercial-ShareAlike 4.0 International license (See https://creativecommons.org/licenses/by-nc-sa/4.0/)
Credits are explicitly not neccesary.